Oxygenated treatment (OT) is a technique used to reduce corrosion in a boiler and its associated feedwater system in flow-through boilers.
With oxygenated treatment, oxygen is injected into the feedwater to keep the oxygen level between 30-50 ppb. "Common injection points are just after the condensate polisher and again at the deaerator outlet." This forms a thicker protective layer of hematite (Fe2O3) on top of the magnetite. This is a denser, flatter film (vs. the undulation scale with OT) so that there is less resistance to water flow compared to AVT. Also, OT reduces the risk of flow-accelerated corrosion.
When OT is used, conductivity after cation exchange (CACE) at the economiser inlet must be maintained below 0.15?S/cm this can be achieved by the use of a condensate polisher.
Video Oxygenated treatment
Comparison of AVT to OT
Maps Oxygenated treatment
See also
- Heat recovery steam generator (HRSG)
- Flow-accelerated corrosion (FAC)
- Oxygen scavenger
- All volatile treatment (AVT)
References
Source of the article : Wikipedia
0 Comments